Set Up Before Riding a Motorcycle

There are several steps that can be done before the drive to reduce the risk of accidents. In addition, these measures are also expected to minimize the fatality if stuck in the road accident

Not just physical readiness of the riders, but also the readiness of vehicles and other supporting aspects.

Set Up Before Riding

We all know, on motorcycles alway need a preparation before riding. Here are some steps that need to be set up before riding a motorcycle.

• Prepare physically. Motorcycling in fit condition are more likely to rate the maximum concentration.

• Check the condition of the brakes. Well-functioning brakes allow maximum braking.

• Check the condition of the chain. For the duck type motorcycle and sports wear chain, it is important to ascertain the condition is quite good.
• Check the condition of tires. Starting from the wind pressure to tire condition.
• Check the condition of the lights. Headlights and signal lights (sign) must be ensured to function properly.
• Check the condition of the fuel. Enough fuel in the tank to support the motorcycle driving comfort.
• Check the condition of the oil. Ensure adequate oil vehicle.
• Check the vehicle papers. Get used to bring a letter of vehicle number (vehicle registration).
• Check the completeness of the letter as a driver's license.
• Prepare helmet. Make sure the helmet is used quite adequate for the protection of the head.
• Prepare jacket. For protection from the wind, wearing a jacket to be the solution to our health.
• Wearing shoes. Inline bike while cycling to reduce the risk of injury and toes cold.
• Prepare gloves.
• Prepare raincoat. Under conditions of the rainy season is important to prepare a raincoat to protect themselves from exposure to the cold and wet.
• Heat the engine for about a minute.

So that is a few steps that need to be set up before riding a motorcycle. Keep savety riding and respect each other.

simple way how to wash a bike

how to wash a bike

after long use, especially after driving, certainly our Bike looks dirty, it is advisable before using again, cleaned beforehand, so that our Bike always look clean and shiny, you can wash it to clean to the washing bike nearby, or if you have a little spare time can be cleaned himself, this job is not too difficult and just requires a little equipment.

• cloth, 
• chamois, 
• buckets,  
• water hoses,  
• brushes and soap

cloth, chamois, buckets, water hoses, brushes and soap

 

Cultivated at the time not to wash each chamois exchange function, it keeps the delicate parts (body, tank, lights) are not scratchy, because if we use a cloth / chamois then impurities such as dirt, asphalt or sand from tires, wheels and the legs will stick feared, damaging other delicate parts.
The soap we use is also not carelessly, appropriate use soap to wash the vehicle, do not use soap to wash clothes

wash starting from the bottom to the top, start by wetting the entire surface of the Bike, and then start rubbing the legs and engine parts, only after that body part or a tank and lights
 

For the drying process, start from the top down to the bottom, with the objective section is dry not hit the water again when wiping the top.

For the tires, having washed, to be more visible we can use polish shiny tires, a lot of brands in the market from cheap to expensive though

there is a little extra, for a Racing exhaust install (usually the output holes wider than the standard), before washing (especially when using steam wash) cover the hole with plastic or other mark use for the exhaust closed, this may litle thing, but if the Bike is often washed rainy season, especially after a long time inside the muffler will rust quickly, usually after washing the Bike, the exhaust given oil few, perhaps protect from rust, but these efforts did not work, so that  exhaust smoke like pogging.

And finally, pay attention to electrical parts, the most problematic part plugs, rubber plugs usually fast brittle and cracked, if you have this caution might after washing the Bike can not turn on, you can cover the first part of the protective rubber plugs with plastic, if you go to washing place usually say to the steam wash, the spark plugs should not be sprayed.

Oke that all a baout washing a bike, i hope this can help you to wash your bike correcly. Thank’s for stop by.

the simple way to maintained your motorcycle

the simple way to maintained your motorcycle

Good motor is a motor-maintained and comfortable to driving, bike maintained will also have a higher selling price when we want to sell. But many do not know how to take care of the motor so durable, many often unconsciously do things that can reduce the quality of their vehicles. This time I will give you some how to take care for motorcycles to remain durable even been used for many years.

• Treatment in the morning.

When you want to use your bike should be heated before the engine, it is useful to create a durable machine. How to heat up the engine also do not directly use electric starter, but use the first starter foot in contact off, then the starter motor in live contact, the engine heat for 5-10 minutes before use. Do not use an electric starter when the motor heats in the morning, it can make the engine sound becomes hard and durable.

• Substitution oil periodically. 

Many people underestimate an oil change with regular motorcycles, motor oil has a very important role for the combustion process in the engine motorcycles. We recommend that you regularly change your motorcycle oil when it reaches its limit of miles.

• Using quality gasoline 

Quality of gasoline affects the quality of your motorcycle engine, preferably in a motorcycle should refuel at petrol depots run by the government. In addition to having good quality, also safe for your vehicle. 

• Use original parts 

For lovers of motorcycles are usually very fond of replacing parts bike looks cool though. If you were also so you should use the original parts, do not use imitation parts. a new motorcycle spare parts soon is the best, so why replace parts when not too important.

That is all, the simple way to maintained your motorcycle, keep in good condition to save your life too, remember allway check your motorcycle before you ride it. Let’s roll brother..!!!